TalonSRX¶
-
class
wpilib.
TalonSRX
(channel)[source]¶ Bases:
wpilib.PWMSpeedController
Cross the Road Electronics (CTRE) Talon SRX Speed Controller via PWM
See also
See
CANTalon
for CAN control of Talon SRX.Constructor for a TalonSRX connected via PWM.
Parameters: channel (int) – The PWM channel that the TalonSRX is attached to. 0-9 are on-board, 10-19 are on the MXP port. Note
The TalonSRX uses the following bounds for PWM values. These values should work reasonably well for most controllers, but if users experience issues such as asymmetric behavior around the deadband or inability to saturate the controller in either direction, calibration is recommended. The calibration procedure can be found in the TalonSRX User Manual available from CTRE.
- 2.004ms = full “forward”
- 1.520ms = the “high end” of the deadband range
- 1.500ms = center of the deadband range (off)
- 1.480ms = the “low end” of the deadband range
- 0.997ms = full “reverse”